Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Traction Control System
Remove reservoir cap. Install hand pump with gauge and hose to reservoir and apply 14.2 psi (1 kg/cm2 ). See upper portion of Fig 1. Connect vinyl tube to bleeder screw of brake actuator and loosen bleeder screw. See lower portion of Fig 1. Bleed air from actuator and tighten bleeder screw to specification. See TORQUE SPECIFICATIONS . Add brake fluid if necessary.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.