For Diagnostics

2004 Toyota Matrix XR, FWD, StandardSECTION For Diagnostics
WARNING: This page is about a different car, the 2003 Toyota Tundra. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch to LOCK position. Disconnect and shield negative battery cable. Wait at least 90 seconds. Remove driver-side air bag module. See DRIVER-SIDE AIR BAG MODULEΒ  under REMOVAL & INSTALLATION. Disconnect passenger-side air bag module connector, accessible through glove box opening. See Fig 1.
  2. Disconnect air bag sensor assembly connectors. See AIR BAG SENSOR ASSEMBLYΒ  under REMOVAL & INSTALLATION. Disconnect right and left seat belt pretensioner connectors. See SEAT BELT PRETENSIONERΒ  under REMOVAL & INSTALLATION. Disconnect right and left front air bag sensors. See FRONT AIR BAG SENSORSΒ  under REMOVAL & INSTALLATION.
Fig 1: Disconnecting Passenger-side Air Bag Connector
G99D20472Courtesy of Β© TOYOTA, LICENSE AGREEMENT TMS1002
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.