Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 266 (AIR BAG RESTRAINT SYSTEMS)DISPOSAL PROCEDURESOFF-VEHICLE DEPLOYMENTSIDE CURTAIN AIR BAG MODULE
2004 Toyota Matrix XR, FWD, Standard
Side Curtain AIR Bag Module
2004 Toyota Matrix XR, FWD, StandardSECTION Side Curtain AIR Bag Module
WARNING: This page is about a different car, the 2003 Lexus ES 300. However, it is still accessible from the selected car via links, so may be relevant.
- Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disable air bag system. See DISABLING SYSTEM under DISABLING & ACTIVATING AIR BAG SYSTEM. Remove appropriate side curtain air bag module. See SIDE CURTAIN AIR BAG MODULE under REMOVAL & INSTALLATION.
- Cut off deployment section (air bag) from inflator. Position side curtain air bag inflator inside a scrap tire and secure with strong wire. See Fig 1. Place this tire between 4 other tires (top tire should have wheel installed). Securely tie all tires together with wire.
- Connect Deployment Tool (09082-00700) and Adapter (09082-00801) to inflator connector. Position deployment tool at least 33 feet (10 m) away from side air bag. Press activation switch to deploy side air bag. Because of heat, wait 30 minutes before handling inflator. Seal deployed inflator in vinyl bag and dispose of in usual manner.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.