Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 265 (AIR BAG RESTRAINT SYSTEMS)DISPOSAL PROCEDURESOFF-VEHICLE DEPLOYMENTDRIVER-SIDE AIR BAG MODULE
2004 Toyota Matrix XR, FWD, Standard
Driver-side AIR Bag Module
2004 Toyota Matrix XR, FWD, StandardSECTION Driver-side AIR Bag Module
WARNING: This page is about a different car, the 2003 Lexus SC 430. However, it is still accessible from the selected car via links, so may be relevant.
- Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disconnect negative battery cable. Remove driver-side air bag module. See DRIVER-SIDE AIR BAG MODULE under REMOVAL & INSTALLATION. Remove connector from rear of driver-side air bag module. Disengage claw and remove driver-side air bag module cover (pad).
- Install 2 bolts (6 mm X 35 mm) with washers into holes located in rear of air bag module and tighten bolts by hand. DO NOT overtighten bolts. Wrap strong wire at least twice around each bolt. See Fig 1. Ensure no slack is present in wire. If slack is present, or wire is not strong enough, driver-side air bag module may become loose due to shock when air bag deploys.
- Position driver-side air bag module on rim of a scrap tire and wheel assembly with pad side facing upward. See Fig 2. Securely tie air bag module to wheel rim through lug nut holes. Place a large cardboard box weighted with at least 44 lbs. (20 kg) at sides or at least 3 scrap tires on top of wheel which air bag module is attached. Each tire must exceed 7.87" (185 mm) wide and 14.17" (360 mm) diameter.
- Connect Deployment Tool (09082-00700) and Adapter (09082-00760) to air bag module connector. Position deployment tool at least 33 feet (10 m) away from air bag module. Press activation switch to deploy air bag. Because of heat, wait 30 minutes before handling driver-side air bag module. Seal deployed air bag in vinyl bag and dispose of in usual manner.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.