Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 263 (AIR BAG RESTRAINT SYSTEMS)DISPOSAL PROCEDURESOFF-VEHICLE DEPLOYMENTPASSENGER-SIDE AIR BAG MODULE
2004 Toyota Matrix XR, FWD, Standard
Passenger-side AIR Bag Module
2004 Toyota Matrix XR, FWD, StandardSECTION Passenger-side AIR Bag Module
WARNING: This page is about a different car, the 2003 Lexus LS 430. However, it is still accessible from the selected car via links, so may be relevant.
- Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disconnect negative battery cable. Remove passenger-side air bag. See PASSENGER-SIDE AIR BAG MODULE under REMOVAL & INSTALLATION.
- Position passenger-side air bag inside a scrap tire with deployment side facing inside of tire. Tire should be at least 7.28" (185 mm) wide and inner diameter should be at least 14.17" (360 mm). Wind strong wire around tire and pass through installation holes in air bag module. See Fig 1. Place this tire between 4 other tires (top tire should have wheel installed). Securely tie all tires together with wire. See Fig 2.
- Connect Deployment Tool (09082-00700) and Adapter (09082-00780) to passenger-side air bag connector. Position deployment tool at least 33 feet (10 m) away from passenger-side air bag. Press activation switch to deploy passenger-side air bag. Because of heat, wait 30 minutes before handling passenger-side air bag. Seal deployed air bag in vinyl bag and dispose of in usual manner.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.