Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 263 (AIR BAG RESTRAINT SYSTEMS)DISABLING & ACTIVATING AIR BAG SYSTEMDISABLING SYSTEMFOR DIAGNOSIS & TESTING
2004 Toyota Matrix XR, FWD, Standard
For Diagnosis & Testing
2004 Toyota Matrix XR, FWD, StandardSECTION For Diagnosis & Testing
WARNING: This page is about a different car, the 2003 Lexus LS 430. However, it is still accessible from the selected car via links, so may be relevant.
- Turn ignition switch to LOCK position. Disconnect and shield negative battery cable. Wait at least 90 seconds. Remove driver-side air bag module. See DRIVER-SIDE AIR BAG MODULE under REMOVAL & INSTALLATION. Disconnect passenger-side air bag module connector, accessible by removing right under cover, No. 2 garnish and finish panel assembly. See Fig 1. See PASSENGER-SIDE AIR BAG MODULE under REMOVAL & INSTALLATION.
- Disconnect air bag sensor assembly connectors. See AIR BAG SENSOR ASSEMBLY under REMOVAL & INSTALLATION. Disconnect right and left front air bag sensors. See FRONT AIR BAG SENSORS . Disconnect right and left front seat belt pretensioners. See FRONT SEAT BELT PRETENSIONERS under REMOVAL & INSTALLATION. Disconnect right and left rear seat belt pretensioners. See REAR SEAT BELT PRETENSIONERS under REMOVAL & INSTALLATION.
- Disconnect right and left side air bag modules. See SIDE AIR BAG MODULES under REMOVAL & INSTALLATION. Disconnect right and left head impact/side air bag sensors. See HEAD IMPACT/SIDE AIR BAG SENSOR ASSEMBLIES under REMOVAL & INSTALLATION. Disconnect right and left side head impact sensors. See HEAD IMPACT AIR BAG SENSOR ASSEMBLIES under REMOVAL & INSTALLATION.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.