Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 262 (AIR BAG RESTRAINT SYSTEMS)DISPOSAL PROCEDURESON-VEHICLE DEPLOYMENT (SCRAPPED VEHICLES ONLY)HEAD IMPACT AIR BAG MODULE
2004 Toyota Matrix XR, FWD, Standard
Head Impact AIR Bag Module
2004 Toyota Matrix XR, FWD, StandardSECTION Head Impact AIR Bag Module
WARNING: This page is about a different car, the 2003 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.
- Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disable air bag system. See DISABLING SYSTEM under DISABLING & ACTIVATING AIR BAG SYSTEM. Access and disconnect head impact air bag module connector located behind rear quarter trim panel. See HEAD IMPACT AIR BAG MODULE under REMOVAL & INSTALLATION.
- Connect Deployment Tools (09082-00700 and 09082-00760) to head impact air bag module connector. Position deployment tool at least 33 feet (10 m) from front of vehicle. Close all doors and windows of vehicle. Connect deployment tool Red clip to positive battery terminal and Black clip to negative battery terminal.
- Ensure no one is inside vehicle or within 33 feet (10 m) of vehicle. Press activation switch to deploy air bag. Because of heat, DO NOT touch air bag for at least 30 minutes after deployment. Scrap vehicle with air bag(s) still installed.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.