Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 262 (AIR BAG RESTRAINT SYSTEMS)DISPOSAL PROCEDURESOFF-VEHICLE DEPLOYMENTSIDE AIR BAG MODULE
2004 Toyota Matrix XR, FWD, Standard
Side AIR Bag Module
2004 Toyota Matrix XR, FWD, StandardSECTION Side AIR Bag Module
WARNING: This page is about a different car, the 2003 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.
- Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disable air bag system. See DISABLING SYSTEM under DISABLING & ACTIVATING AIR BAG SYSTEM. Remove appropriate side air bag. See SIDE AIR BAG MODULE under REMOVAL & INSTALLATION. Install nut on each stud located on rear of side air bag module. Wrap strong wire at least twice around each stud. See Fig 1. Ensure no slack is present in wire.
- Position side air bag inside a scrap tire with air bag deployment direction facing inside and secure with strong wire. See Fig 1. Place this tire between 4 other tires (top tire should have wheel installed). Securely tie all tires together with wire.
- Connect Deployment Tools (09082-00700 and 09082-00750) to side air bag connector. Position deployment tool at least 33 feet (10 m) away from side air bag. Press activation switch to deploy side air bag. Because of heat, wait 30 minutes before handling side air bag. Seal deployed air bag module in vinyl bag and dispose of in usual manner.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.