Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 261 (ENGINE MECHANICAL)ENGINE SPECIFICATIONSCYLINDER BLOCK
2004 Toyota Matrix XR, FWD, Standard
Cylinder Block
2004 Toyota Matrix XR, FWD, StandardSECTION Cylinder Block
WARNING: This page is about a different car, the 2002 Lexus LS 430. However, it is still accessible from the selected car via links, so may be relevant.
CYLINDER BLOCK
| Application | In. (mm) | |||||
|---|---|---|---|---|---|---|
| Cylinder Bore Standard Diameter (1) | ||||||
| Size Mark "1" | 3.5827-3.5830 (91.000-91.008) | |||||
| Size Mark "2" | 3.5830-3.5835 (91.008-91.020) | |||||
| Size Mark "3" | 3.5835-3.5838 (91.020-91.029) | |||||
| Main Bearing Bore Inside Diameter (2) | ||||||
| Size Mark "00" | 2.83464 (72.000) | |||||
| Size Mark "01" | 2.83467 (72.001) | |||||
| Size Mark "02" | 2.83471 (72.002) | |||||
| Size Mark "03" | 2.83475 (72.003) | |||||
| Size Mark "04" | 2.83479 (72.004) | |||||
| Size Mark "05" | 2.83483 (72.005) | |||||
| Size Mark "06" | 2.83487 (72.006) | |||||
| Size Mark "07" | 2.83491 (72.007) | |||||
| Size Mark "08" | 2.83495 (72.008) | |||||
| Size Mark "09" | 2.83499 (72.009) | |||||
| Size Mark "10" | 2.83503 (72.010) | |||||
| Size Mark "11" | 2.83507 (72.011) | |||||
| Size Mark "12" | 2.83511 (72.012) | |||||
| Size Mark "13" | 2.83515 (72.013) | |||||
| Size Mark "14" | 2.83519 (72.014) | |||||
| Size Mark "15" | 2.83523 (72.015) | |||||
| Size Mark "16" | 2.83526 (72.016) | |||||
| Maximum Deck Warpage | .0028 (.071) | |||||
|
||||||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.