Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 230 (ELECTRICAL COMPONENT LOCATOR)SWITCHES
2004 Toyota Matrix XR, FWD, Standard
Section 230 (Electrical Component Locator): Switches
2004 Toyota Matrix XR, FWD, StandardSECTION Switches
WARNING: This page is about a different car, the 2003 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.
SWITCHES LOCATION
| Component | Component Location |
|---|---|
| A/C Triple Pressure Switch (Dual & Single) | On right front of engine compartment. See Figure. |
| Brake Fluid Level Warning Switch | On brake fluid reservoir. See Figure. |
| Buckle Switch (Left/Right) | Inside of respective front seat belt buckle. |
| Engine Hood Courtesy Switch | On left center of radiator support. |
| Oil Pressure Switch | On left front of engine. See Figure. |
| Parking Brake Switch | Behind left side of dash, on parking brake lever. See Figure. |
| Park/Neutral Position Switch (2WD) | On transmission. |
| Park/Neutral Position Switch (4WD) | On transmission. See Figure. |
| Stoplight Switch | On bracket above brake pedal. See Figure. |
| Transfer L4 Position Detection Switch | On transfer case. See Figure. |
| Transfer Neutral Position Detection Switch | On transfer case. See Figure. |
| Transfer Position Detection Switch No. 1 | On transfer case. See Figure. |
| Transfer Position Detection Switch No. 2 | On transfer case. See Figure. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.