Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 230 (ELECTRICAL COMPONENT LOCATOR)SPLICES
2004 Toyota Matrix XR, FWD, Standard
Section 230 (Electrical Component Locator): Splices
2004 Toyota Matrix XR, FWD, StandardSECTION Splices
WARNING: This page is about a different car, the 2003 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.
SPLICES LOCATION
| Component | Component Location |
|---|---|
| B1 | In body harness, at base of left "A" pillar. See Figure. |
| B2 | In body harness, at center of windshield header. See Figure. |
| B3 | In body harness, under left side of rear seat. See Figure. |
| B4 | In body harness, behind left taillight assembly. See Figure. |
| B5 | In body harness, in right rear quarterpanel. See Figure. |
| E1 | In engine harness, at top center rear of engine. See Figure. |
| E2 | In engine harness, at top center rear of engine. See Figure. |
| E3 | In engine harness, near brake master cylinder. See Figure. |
| E4 | In engine harness, near brake master cylinder. See Figure. |
| I3 | In dash harness, under left rear of center console. See Figure. |
| I4 | In dash harness, behind right side of dash. See Figure. |
| I5 | In dash harness, behind right side of dash. See Figure. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.