Circuit Protection Devices

2004 Toyota Matrix XR, FWD, StandardSECTION Circuit Protection Devices
WARNING: This page is about a different car, the 2003 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.
CIRCUIT PROTECTION DEVICES LOCATION

Component Component Location
Driver Side R/B No. 1 Behind left end of dash, below instrument panel J/B.
Engine Room J/B On left side of engine compartment.
Engine Room R/B No. 2 On left side of engine compartment.
Engine Room R/B No. 3 On left side of engine compartment.
Fusible Link Block In engine room J/B.
Instrument Panel J/B Behind left end of dash. See Figure.
Sub J/B No. 3 Behind right side of instrument cluster. See Figure.
Sub J/B No. 4 Behind right side of instrument cluster. See Figure.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.