SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 221 (POWER WINDOWS)ADJUSTMENTSPOWER WINDOW MOTOR (LIMIT SWITCH & PULSE SWITCH) RESET
2004 Toyota Matrix XR, FWD, Standard

Power Window Motor (Limit Switch & Pulse Switch) Reset

2004 Toyota Matrix XR, FWD, StandardSECTION Power Window Motor (Limit Switch & Pulse Switch) Reset
WARNING: This page is about a different car, the 2003 Lexus IS 300 and 2002 Lexus IS 300. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: It is necessary to reset the power window motor (in initial position for the limit switch) when separating the window regulator from the power window motor or operating with the door glass not installed.
    NOTE: Place the matchmarks on the power window motor and window regulator gear.
  1. Remove the power window motor. See POWER WINDOW REGULATOR MOTOR (FRONT)  or POWER WINDOW REGULATOR MOTOR (REAR)  under REMOVAL & INSTALLATION.
  2. Connect the power window motor and power window switch to wiring harness of the vehicle.
  3. Turn the ignition switch ON and operate the power window switch to idle the power window motor in UP side direction for more than 6 rotations or less than 10 rotations (4 seconds or more).
  4. Assemble the power window motor and regulator.
    • Install the motor when the regulator arm is below the middle point.
    • Align the matchmarks on the power window motor and window regulator gear.
    5. CAUTION: Never rotate the motor to the down direction until the completion of the window glass installation.
  5. Assemble the power window regulator and door glass.
  6. Connect the power window switch to the wiring harness and turn the ignition switch ON.
  7. Repeat UP and DOWN operation several times manually.
    8. NOTE: Take care that the jam protection function does not operate just after resetting. Reset the regulator again when performing the reverse operating after closing the window fully by AUTO UP operation.
  8. Check if AUTO UP to AUTO DOWN operates in automatic operation.
  9. Check the power window function.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.