Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 218 (WIPER/WASHER SYSTEM)REMOVAL & INSTALLATIONWIPER MOTOR (REAR)REMOVAL
2004 Toyota Matrix XR, FWD, Standard
Wiper Motor (Rear): Removal
2004 Toyota Matrix XR, FWD, StandardSECTION Removal
WARNING: This page is about a different car, the 2003 Lexus IS 300 and 2002 Lexus IS 300. However, it is still accessible from the selected car via links, so may be relevant.
- Using a screwdriver, remove the back door trim board upper. See Fig 1.
- Remove the back door trim covers. See Fig 2. Insert a screwdriver between the back door panel and back door trim cover to pry the cover.
- Remove the back door trim board. See Fig 3. Remove the clip and back door handle. Using a screwdriver, remove the back door trim board.
- Remove the wiper arm cover. Place the matchmarks on the wiper arm and wiper motor. See Fig 4. Remove the nut and rear wiper arm.
- Remove the rear wiper motor. Remove the nut and washer on the outer side of the back door panel. Disconnect the connector. Remove the 3 bolts and rear wiper motor.
NOTE:
Tape the screwdriver tip before use.
NOTE:
Tape the screwdriver tip before use.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.