Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Wiper/Washer Switch (Front)
Inspect the front wiper and washer switch continuity. See CONNECTOR IDENTIFICATION . See INSPECTING FRONT WIPER/WASHER SWITCH CONTINUITY table. If continuity is not as specified, replace the switch. See WIPER/WASHER SWITCH under REMOVAL & INSTALLATION.
| Switch Position | Tester Connection | Specified Condition |
|---|---|---|
| OFF | 7 - 16 | Continuity |
| INT | 7 - 16 | Continuity |
| LO | 7 - 17 | Continuity |
| HI | 8 - 17 | Continuity |
| Washer OFF | - | No Continuity |
| Washer ON | 2 - 11 | Continuity |
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.