Front Wiper Motor: Removal

2004 Toyota Matrix XR, FWD, StandardSECTION Removal
WARNING: This page is about a different car, the 2002 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition off. Remove wiper arm caps, nuts and arms. Carefully pull off hood-to-cowl top seal by pulling toward front of vehicle. Using a clip remover, remove 2 cowl top ventilator retaining clips, and remove cowl top ventilator louvre. See Figure.
  2. Disconnect Black 5-pin electrical harness connector from front wiper motor and route wiring harness away from work area. Remove 4 bolts from front wiper motor and link assembly, and remove front wiper motor and link assembly.
  3. Using a screwdriver with tape applied to tip, disconnect wiper link from wiper motor. Remove 3 bolts and front wiper motor from wiper link assembly.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.