Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 216 (CRUISE CONTROL SYSTEM)DESCRIPTION & OPERATIONSYSTEM OUTLINEMANUAL CANCEL MECHANISM
2004 Toyota Matrix XR, FWD, Standard
Manual Cancel Mechanism
2004 Toyota Matrix XR, FWD, StandardSECTION Manual Cancel Mechanism
WARNING: This page is about a different car, the 2002 Lexus IS 300. However, it is still accessible from the selected car via links, so may be relevant.
If any of the following signals are input during cruise control driving, the current to the motor flows in the direction to close the throttle valve, and the cruise control is canceled. Vehicle speed memory will not be erased.
- Stop light switch is on (brake pedal is depressed).
- On vehicles with automatic transmission, D position circuit in the park/neutral position switch is turned from ON to OFF (shift position is changed from D to N, 2 or 1).
- On vehicles with manual transmission, the cruise control clutch switch is on.
- The CANCEL switch of the control switch is on.
- The CRUISE switch is off (vehicle speed memory will be erased).
- On vehicles with automatic transmission, the shift lever in M position and shift range other than D or 3 position.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.