Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 210 (BODY CONTROL SYSTEM)CIRCUIT TESTSIGNITION SWITCH POWER SOURCE CIRCUITINSPECTION PROCEDURE
2004 Toyota Matrix XR, FWD, Standard
Inspection Procedure
2004 Toyota Matrix XR, FWD, StandardSECTION Inspection Procedure
WARNING: This page is about a different car, the 2003 Lexus IS 300 and 2002 Lexus IS 300. However, it is still accessible from the selected car via links, so may be relevant.
- Check the continuity of the ECU-IG and RADIO NO. 2 fuses. See COMPONENT LOCATIONS . If there is continuity, go to the next step. If there is not continuity, replace the failed fuse.
- Turn the ignition switch ON. Measure the voltage between terminals No. 4 (ACC), No. 3 (IG) and No. 12 (GND) of the body ECU connector. See CONNECTOR IDENTIFICATION . If voltage is 10-14 V, proceed to the next circuit inspection of the symptom. See PROBLEM SYMPTOM INDEX table. If the voltage is not as specified, go to the next step.
- Check the wiring harness and connector between the body ECU and body ground. See WIRING DIAGRAMS . If the results are OK, check and repair the wiring harness and connector between the body ECU and battery. If the results are not OK, repair or replace the wiring harness or connector.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.