Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 207 (MULTIPLEX COMMUNICATION SYSTEM)DIAGNOSTIC TESTSDTC B1211/11: POWER WINDOW MASTER SWITCH ECU COMMUNICATION STOPDIAGNOSTIC PROCEDURE
2004 Toyota Matrix XR, FWD, Standard
Diagnostic Procedure
2004 Toyota Matrix XR, FWD, StandardSECTION Diagnostic Procedure
WARNING: This page is about a different car, the 2003 Lexus IS 300 and 2002 Lexus IS 300. However, it is still accessible from the selected car via links, so may be relevant.
- Check if driver door window glass auto up function operates. With this inspection, the power window master ECU can be diagnosed if it works normally or not. If the results are OK, go to the next step. If the results are not good, replace the faulty power window master switch. See POWER WINDOWS article under WINDOWS in ACCESSORIES & EQUIPMENT.
- Disconnect the connector of the body ECU and P8 of the power window master switch. Check the continuity between terminal 6 (MPX3) of the body ECU and terminal 18 (TX) of the power window master switch. See CONNECTOR IDENTIFICATION . If there is continuity in the wiring harness, replace the faulty power window master switch. See POWER WINDOWS article under WINDOWS in ACCESSORIES & EQUIPMENT. If there is an open in the wiring harness, repair it. If there is not continuity, repair or replace the faulty wiring harness. See POWER WINDOWS in SYSTEM WIRING DIAGRAMS article.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.