Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 206 (CRUISE CONTROL)SELF-DIAGNOSTIC SYSTEMINPUT SIGNAL CHECK
2004 Toyota Matrix XR, FWD, Standard
Input Signal Check
2004 Toyota Matrix XR, FWD, StandardSECTION Input Signal Check
WARNING: This page is about a different car, the 2003 Lexus RX 300 and 2002 Lexus RX 300. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- For Check No. 1-3 - Turn the ignition switch ON.
- For Check No. 4 - Jack up the vehicle, start the engine and shift to "D" position.
- Pull the control switch to SET/COAST or RES/ACC position and hold it down or up. See Figure
- Push the main switch ON.
- Check that the CRUISE MAIN indicator light blinks twice or 3 times repeatedly after 3 seconds.
- Turn the SET/COAST or RES/ACC switch OFF.
- Operate each switch as listed in the table. See Fig 1.
- Read the blinking pattern of the CRUISE MAIN indicator light.
- After performing the check, turn the main switch OFF.
NOTE:
When 2 or more signals are input to the ECU, the lowest number code will be displayed 1st.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.