Component Locations

2004 Toyota Matrix XR, FWD, StandardSECTION Component Locations
WARNING: This page is about a different car, the 2002 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: For power seat component locations, see illustration. See Fig 1.
COMPONENT LOCATIONS

Component Location
Body Control Electronic Control Unit Attached To Driver Side Junction Block
Driver Side Junction Block Left Side Of Instrument Panel, Behind Access Panel To Left Of Steering Column
Driving Position Memory Switch (With Driving Position Memory) Front Left Side Of Driver Power Seat
Engine Compartment Junction Block Left Side Of Engine Compartment, In Front Of Shock Tower
Front Vertical Motor Left Center Under Seat
Front Vertical Motor Position Sensor (With Driving Position Memory) Integral With Front Vertical Motor
Lumbar Support Switch Rear Left Side Of Power Seat
Power Seat Electronic Control Unit (With Driving Position Memory) Under Center Of Driver Power Seat
Power Seat Control Switch Front Left Side Of Power Seat, In Front Seat Back Angle Switch
Rear Vertical Motor Right Center Under Seat
Rear Vertical Motor Position Sensor (With Driving Position Memory) Integral With Rear Vertical Motor
Recline Motor Right Rear Corner Under Seat
Recline Motor Position Sensor (With Driving Position Memory) Integral With Recline Motor
Seat Back Angle Button On Power Seat Control Switch
Seat Back Heater In Seat Back Of Front Seats
Seat Cushion Heater In Seat Cushion Of Front Seats
Seat Heater Switches On A/C-Heater Control Panel
Seat Position & Seat Cushion Angle Button On Power Seat Control Switch
Slide Motor Right Front Corner Under Seat
Slide Motor Position Sensor (With Driving Position Memory) Integral With Slide Motor
Stoplight Switch Near Top Of Brake Pedal
Fig 1: Identifying Power Seat & Seat Heater Components
G00124423Courtesy of Β© TOYOTA, LICENSE AGREEMENT TMS1002
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.