Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 201 (POWER MIRROR CONTROL SYSTEM)REMOVAL & INSTALLATIONMIRROR GLASS REPLACEMENT
2004 Toyota Matrix XR, FWD, Standard
Mirror Glass Replacement
2004 Toyota Matrix XR, FWD, StandardSECTION Mirror Glass Replacement
WARNING: This page is about a different car, the 2002 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
- Press in inboard side of mirror glass to gain access to back of mirror. Reach fingers behind outboard side of mirror glass and carefully unlatch both ends of wire retainer. See Fig 1. Disconnect mirror heater electrical harness connector, if equipped, and remove mirror glass.
- To install new mirror glass, connect mirror heater electrical harness connector, if equipped. Install wire retainer to back of mirror. Carefully align 2 alignment tabs on back of mirror with slots on mirror motor inside housing.
- Firmly press mirror glass into place to engage all 6 lugs of wire retainer. See Fig 1. Using light pressure, press on mirror glass with open palm and rock mirror through full range of motion to ensure all 6 lugs of wire retainer are engaged on back of mirror. Confirm all retainer lugs are engaged on back of mirror by gently pulling on edges of mirror. Operate power mirror to ensure it operates through full range of motion.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.