Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Circuit Description
Heated Air/Fuel (A/F) sensor monitors exhaust gas oxygen content and delivers input signals to ECM. Heated A/F sensor is located on exhaust pipe in front of catalytic converter. A/F sensor may also be referred to as A/F sensor (bank No. 1 sensor No. 1) or A/F ratio sensor. ECM uses input signals to determine fuel injection system operation. DTC is set when A/F sensor output voltage does not change after engine is started with engine at normal operating temperature. Possible causes are:
- A/F sensor circuit is open or shorted.
- Defective A/F sensor.
- Air induction system malfunction.
- Improper fuel pressure.
- Defective fuel injector.
- Vehicle has run out of fuel.
- Defective ECM.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.