Window Up

2004 Toyota Matrix XR, FWD, StandardSECTION Window Up
WARNING: This page is about a different car, the 2003 Lexus RX 300 and 2002 Lexus RX 300. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Sensor may be damaged if wiring harness is connected incorrectly.
  1. Connect the negative (-) lead from the ohmmeter to terminal No. 4 and the positive (+) lead to terminal No. 5. See CONNECTOR IDENTIFICATIONΒ .
  2. Connect the positive (+) lead from the battery to terminal No. 2 and the negative (-) lead to terminal No. 1.
  3. Check that the continuity exists when the window goes up.
  4. Check that no continuity exists when the window is in the fully closed position. If operation is not as specified, replace the motor. See WINDOW REGULATOR (FRONT DOOR)Β  under REMOVAL & INSTALLATION.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.