SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 193 (WIPER/WASHER SYSTEMS)REMOVAL & INSTALLATIONREAR WIPER MOTORINSTALLATION
2004 Toyota Matrix XR, FWD, Standard

Rear Wiper Motor: Installation

2004 Toyota Matrix XR, FWD, StandardSECTION Installation
WARNING: This page is about a different car, the 2003 Lexus RX 300 and 2002 Lexus RX 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the rear wiper motor. Install the packing to the motor. Install the rear wiper motor and tighten the 3 bolts. See TORQUE SPECIFICATIONS  table. Connect the connector. Install the washer and nut on the outer side of the back door panel. See TORQUE SPECIFICATIONS  table.
  2. Install the rear wiper arms and tighten the nut by hand. Operate the wipers once and turn the wiper switch OFF. Adjust the rear wiper arms. See REAR WIPER ARMS under ADJUSTMENTS . Install the rear wiper arm with the nut. See TORQUE SPECIFICATIONS  table.
  3. Install the back door trim board to the back door panel.
  4. Install the upper back door trim to the back door panel.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.