Front Wiper Motor & Linkage Assembly: Removal

2004 Toyota Matrix XR, FWD, StandardSECTION Removal
WARNING: This page is about a different car, the 2003 Lexus RX 300 and 2002 Lexus RX 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the wiper arms. Remove the nut and LH wiper arm. Remove 2 nuts and the RH wiper arm. See Fig 1.
  2. Remove the cowl louvers. Remove the weatherstrip from the cowl louvers. Remove the clips, then pull the cowl louvers forward.
  3. Remove the wiper link assembly by disconnecting the connector and removing 5 bolts.
  4. Remove the wiper motor. Remove the nut. Place matchmarks on the wiper link and motor. See Fig 2. Remove the 3 bolts and motor from the wiper link.
  5. NOTE: Tape the screwdriver tip before use.
  6. Remove the washer nozzles. Disconnect the washer hoses. Using a screwdriver, remove the washer nozzles from the hood.
Fig 1: Exploded View Of Front Wiper Motor & Linkage Assembly
G99G50134Courtesy of Β© TOYOTA, LICENSE AGREEMENT TMS1002
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.