SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 191 (INSTRUMENT PANEL)COMPONENT TESTSHAZARD WARNING SWITCH
2004 Toyota Matrix XR, FWD, Standard

Hazard Warning Switch

2004 Toyota Matrix XR, FWD, StandardSECTION Hazard Warning Switch
WARNING: This page is about a different car, the 2002 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition off. Remove hazard warning switch from center air ventilation grille. Disconnect 10-pin electrical harness connector from switch. Note hazard warning switch electrical terminals and switch positions.
  2. Using a DVOM, check continuity between specified terminals of hazard warning switch with switch in specified position. See Fig 1. See HAZARD WARNING SWITCH CONTINUITY  table. Replace hazard warning switch if defective.
    HAZARD WARNING SWITCH CONTINUITY

    Switch Position Test Between Terminals (1) Specification
    OFF 5 & 7 Continuity
    ON 5 & 6; 1, 2, 3 & 4 Continuity
    Illumination Circuit 8 & 9 Continuity
    (1) See Fig 1.
    Fig 1: Identifying Hazard Warning Switch Terminals
    G00203242Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.