Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 190 (STEERING COLUMN SWITCHES)REMOVAL & INSTALLATIONCOMBINATION SWITCHDISASSEMBLY & REASSEMBLY
2004 Toyota Matrix XR, FWD, Standard
Disassembly & Reassembly
2004 Toyota Matrix XR, FWD, StandardSECTION Disassembly & Reassembly
WARNING: This page is about a different car, the 2003 Lexus RX 300 and 2002 Lexus RX 300. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the column cover by removing 3 screws.
- Remove the light control switch. Disconnect the connector and remove the 2 screws. See Fig 1.
- Remove the wiper and washer switch. Disconnect the connector and remove the 2 screws.
- For reassembly, reverse the disassembly procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.