Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 188 (INSTRUMENT PANEL)CIRCUIT TESTSFUEL GAUGE CIRCUIT
2004 Toyota Matrix XR, FWD, Standard
Fuel Gauge Circuit
2004 Toyota Matrix XR, FWD, StandardSECTION Fuel Gauge Circuit
WARNING: This page is about a different car, the 2003 Lexus RX 300 and 2002 Lexus RX 300. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
If not using the hand-held tester, start the inspection from step 2.
- Perform the active test. Connect the hand-held tester to the DLC3. See Figure. Enter into ACTIVE TEST function of the hand-held tester. Check that the probe moves as the hand-held tester directs in each range. If the gauge operates normally, replace the A/C and combination meter integrated ECU. See COMBINATION METER under REMOVAL & INSTALLATION. If the gauge does not operate normally, go to the next step.
- Check the fuel sender gauge. See FUEL SENDER GAUGE under COMPONENT TESTS. If the results are OK, go to the next step. If the results are not good, replace the fuel sender gauge.
- Check for a short circuit (B+) in the harness and connector between the A/C and combination meter integrated ECU and fuel sender gauge. If the results are OK, go to the next step. If the results are not good, repair or replace the harness or connector.
- Check the fuel receiver gauge. See FUEL RECEIVER GAUGE under COMPONENT TESTS. If the results are OK, check and replace the combination meter circuit plate. See COMBINATION METER under REMOVAL & INSTALLATION. If the results are not good, replace the fuel receiver gauge.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.