Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 183 (ANTI-LOCK)REMOVAL & INSTALLATIONBRAKE ACTUATOR ASSEMBLYINSTALLATION
2004 Toyota Matrix XR, FWD, Standard
Brake Actuator Assembly: Installation
2004 Toyota Matrix XR, FWD, StandardSECTION Installation
WARNING: This page is about a different car, the 2002 Lexus IS 300. However, it is still accessible from the selected car via links, so may be relevant.
- To install, reverse removal procedure. Install 3 cushions and 2 cushion bolts to brake actuator. Install brake actuator to bracket with 2 nuts and tighten to specification. See TORQUE SPECIFICATIONS .
- Install nut, 2 bolts and brake actuator assembly. Tighten to specification. See TORQUE SPECIFICATIONS .
- Connect brake hose and connector.
- Using special tool (09023-00100), connect 6 brake lines to actuator and tighten to specification. See TORQUE SPECIFICATIONS .
- Fill reservoir with brake fluid and bleed brake system. See BLEEDING BRAKE SYSTEM .
- Check for brake fluid leakage.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.