SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 170 (CRUISE CONTROL SYSTEMS)SELF-DIAGNOSTIC SYSTEMCONFIRMATION TEST
2004 Toyota Matrix XR, FWD, Standard

Confirmation Test

2004 Toyota Matrix XR, FWD, StandardSECTION Confirmation Test
WARNING: This page is about a different car, the 2002 Lexus GS 430 and 2002 Lexus GS 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect the SET switch. Push the main switch ON. Drive at a desired speed (25 mph or higher). Press the control switch to the SET/COAST. See Fig 1. After releasing the switch, check that the vehicle cruises at the desired speed.
  2. Inspect the ACCEL switch. Push the main switch ON. Drive at a desired speed (25 mph or higher). Check that the vehicle speed increases while the control switch is turned to RES/ACC, and that the vehicle cruises at the set speed when the switch is released. Momentarily press the control switch upward in the RES/ACC and then immediately release it. Check that the vehicle speed increases by about 0.93 mph, tap-up function.
  3. Inspect the COAST switch. Push the main switch ON. Drive at a desired speed (25 mph or higher). Check that the vehicle speed decreases while the control switch is turned to SET/COAST, and the vehicle cruises at the set speed when the switch is released. Momentarily press the control switch is turned to SET/COAST, and then immediately release it. Check that the vehicle speed decreases by about 0.93 mph, tap-down function.
  4. Inspect the CANCEL switch. Push the main switch ON. Drive at a desired speed (25 mph or higher). When operating one of the following, check that the cruise control system is cancelled and that the normal driving mode is reset.
    • Depress the brake pedal.
    • Shift to except D position (A/T).
    • Push the main switch OFF.
    • Pull the cruise control switch to CANCEL.
  5. Inspect the RESUME switch. Push the main switch ON. Drive at a desired speed (25 mph or higher). When operating one of the following, check that the cruise control system is cancelled and that the normal driving mode is reset.
    • Depress the brake pedal.
    • Shift to except D position (A/T).
    • Pull the cruise control switch to CANCEL.
    After the control switch is turned to RES/ACC at the driving speed of more than 25 mph, check that the vehicle restores the speed prior to the cancellation.
Fig 1: Inspecting Cruise Control Switch Operation
G00178271Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.