Clearing Diagnostic Trouble Codes

2004 Toyota Matrix XR, FWD, StandardSECTION Clearing Diagnostic Trouble Codes
WARNING: This page is about a different car, the 2002 Lexus GS 430 and 2002 Lexus GS 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. The following actions will erase the DTCs and freeze frame data.
    • Operating the OBD II scan tool (complying with SAE J1978) or hand-held tester to erase the codes. See the OBD II scan tool's instruction book for operating instructions.
    • Disconnecting the battery terminals or EFI fuse.
  2. After completing repairs, the DTC retained in memory can be cleared by removing the ECU-B1 (20-amp) fuse in engine room No. 1 relay block for 10 seconds or more with the ignition switch off.
  3. Check that the normal code is displayed after connecting the fuse.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.