Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 17 (ENGINE CONTROL SYSTEM SELF-DIAGNOSTICS)DIAGNOSTIC TESTSDTC P0116: ENGINE COOLANT TEMPERATURE SENSOR CIRCUIT RANGE/PERFORMANCEDIAGNOSIS & REPAIR
2004 Toyota Matrix XR, FWD, Standard
Diagnosis & Repair
2004 Toyota Matrix XR, FWD, StandardSECTION Diagnosis & Repair
WARNING: This page is about a different car, the 2002 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
- Using Toyota hand-held tester or scan tool, check for any other DTCs. If only DTC P0116 exists, go to next step. If other DTCs exist, diagnose and repair those DTCs first and retest.
- Remove and inspect cooling system thermostat for damage and proper operation. Thermostat is located behind thermostat housing on passenger's side front of engine where upper radiator hose is attached. If thermostat is defective, replace thermostat. If thermostat is okay, replace ECT sensor. ECT sensor is located on passenger's side of coolant pipe at front of engine, in front of intake manifold and contains Black 2-pin electrical connector with Green/Black and Brown/White wires. See ENGINE COOLANT TEMPERATURE SENSOR under ENGINE SENSORS & SWITCHES in REMOVAL, OVERHAUL & INSTALLATION - V6 & V8 article.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.