Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 165 (POWER WINDOWS)COMPONENT TESTSPOWER WINDOW MOTOR PTC OPERATION (REAR)
2004 Toyota Matrix XR, FWD, Standard
Power Window Motor PTC Operation (Rear)
2004 Toyota Matrix XR, FWD, StandardSECTION Power Window Motor PTC Operation (Rear)
WARNING: This page is about a different car, the 2002 Lexus GS 430 and 2002 Lexus GS 300. However, it is still accessible from the selected car via links, so may be relevant.
- Inspect the power window motor PTC operation.
- Disconnect the connector from the rear door ECU.
- Connect the positive (+) lead from the battery to terminal No. 3 and the negative (-) lead to terminal No. 1 on the wire harness side connector, and raise the window to full closed position. See CONNECTOR IDENTIFICATION .
- Continue to apply voltage and check that there is a PTC operation noise within approximately 4-90 seconds.
- Reverse the polarity and check that the window begins to descend within approximately 60 seconds.
- If operation is not as specified, replace the motor. See REAR DOOR POWER WINDOW REGULATOR under COMPONENT TESTS.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.