Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Key Unlock Warning Switch
Inspect the key unlock warning switch continuity. See CONNECTOR IDENTIFICATION . See INSPECTING KEY UNLOCK WARNING SWITCH CONTINUITY table. If the continuity is not as specified, replace the key unlock warning switch. See appropriate POWER TILT & TELESCOPIC STEERING COLUMN article in STEERING.
| Switch Position | Tester Connection | Specified Condition |
|---|---|---|
| OFF (Key Removed) | ..... | No Continuity |
| ON (Key Set) | 1 - 2 | Continuity |
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.