Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 161 (STEERING COLUMN SWITCHES)CIRCUIT TESTSFOG LIGHT SWITCH CIRCUIT
2004 Toyota Matrix XR, FWD, Standard
Fog Light Switch Circuit
2004 Toyota Matrix XR, FWD, StandardSECTION Fog Light Switch Circuit
WARNING: This page is about a different car, the 2003 Lexus GS 430, 2003 Lexus GS 300, 2002 Lexus GS 430, and 2002 Lexus GS 300. However, it is still accessible from the selected car via links, so may be relevant.
- Connector Disconnected -
Inspect the fog light switch circuit. See LIGHT CONTROL SWITCH CIRCUIT under CIRCUIT TESTS in BODY CONTROL SYSTEMS
article under COMMUNICATION DEVICES in ACCESSORIES & EQUIPMENT. Disconnect the connector from the switch and inspect the connector on the wire harness side. For the front side of the combination switch connector, see CONNECTOR IDENTIFICATION . See INSPECTING FOG LIGHT SWITCH CIRCUIT (DISCONNECTED) table. If the circuit is not as specified, inspect the wire harness. See WIRING DIAGRAMS .INSPECTING FOG LIGHT SWITCH CIRCUIT (DISCONNECTED)
Tester Connection Condition Specified Condition 11 - Ground Light Control Switch TAIL Or HEAD & Dimmer Switch LOW Or HI Continuity - Connector Connected -
Inspect the fog light switch circuit. Connect the wire harness side connector to the light control and dimmer switch and inspect the connector from the back side. For the front side of the combination switch connector, see CONNECTOR IDENTIFICATION . See INSPECTING FOG LIGHT SWITCH CIRCUIT (CONNECTED) table. If the circuit is not as specified, inspect the wire harness. See WIRING DIAGRAMS .INSPECTING FOG LIGHT SWITCH CIRCUIT (CONNECTED)
Tester Connection Condition Specified Condition 11 - Ground Light Control Switch HEAD & Headlight Dimmer Switch LO & Fog Light Switch ON No Voltage 11 - Ground Light Control Switch HEAD & Headlight Dimmer Switch HI Or FLASH & Fog Light Switch ON B+ Voltage
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.