SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 16 (ENGINE CONTROL SYSTEM SELF-DIAGNOSTICS - V6)SCAN TOOL PROBLEMSDATA LINK CONNECTOR NO. 3 INSPECTION
2004 Toyota Matrix XR, FWD, Standard

Data Link Connector No. 3 Inspection

2004 Toyota Matrix XR, FWD, StandardSECTION Data Link Connector No. 3 Inspection
WARNING: This page is about a different car, the 2002 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. If Toyota hand-held tester or scan tool displays UNABLE TO CONNECT TO VEHICLE when hand-held tester or scan tool is connected to Data Link Connector (DLC) No. 3, try hand-held tester or scan tool on another vehicle. If hand-held tester or scan tool operates on another vehicle, go to next step. If hand-held tester or scan tool does not operate on another vehicle, problem is probably with hand-held tester or scan tool.
  2. Check DLC No. 3 for loose or damaged terminals. Ensure DLC No. 3 terminals are in correct position in connector. See WIRING DIAGRAMS article. For full wiring diagram of DLC No. 3, it may be necessary to see DATA LINK CONNECTORS article in WIRING DIAGRAMS . If connector and terminals are okay, go to next step. If connector or terminals are defective, repair as necessary.
  3. Check voltage and resistance between ground and specified terminal on DLC No. 3. See DATA LINK CONNECTOR NO. 3 VOLTAGE & RESISTANCE SPECIFICATIONS  table. See Fig 1. If voltage or resistance readings are not within specification, check wiring circuit. See WIRING DIAGRAMS article.
    DATA LINK CONNECTOR NO. 3 VOLTAGE & RESISTANCE SPECIFICATIONS

    Terminal No. (Circuit) Specification
    4 (Chassis Ground) 1 Ohm Or Less
    5 (Signal Ground) 1 Ohm Or Less
    7 (BUS Communication) (1)
    16 (Battery Voltage) 9-14 Volts
    (1) Pulse generation should exist during information transmission from Engine Control Module (ECM).
    Fig 1: Identifying Data Link Connector No. 3 Terminals
    G99C52821Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.