SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 153 (CRUISE CONTROL SYSTEMS)REMOVAL & INSTALLATIONSTEERING PAD SWITCHREMOVAL & INSTALLATION
2004 Toyota Matrix XR, FWD, Standard

Removal & Installation

2004 Toyota Matrix XR, FWD, StandardSECTION Removal & Installation
WARNING: This page is about a different car, the 2003 Lexus ES 300 and 2002 Lexus ES 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the connector cover by using a screwdriver to disengage the 3 claws. See Fig 1.
  2. Remove the steering pad switch by removing the 2 screws and disconnecting the connector. See Fig 2.
  3. For installation, reverse the removal procedure.
Fig 1: Removing Connector Cover
G00178258Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.