Setting Driving Position

2004 Toyota Matrix XR, FWD, StandardSECTION Setting Driving Position
WARNING: This page is about a different car, the 2002 Lexus ES 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Adjust the driver's seat and the outside rear view mirrors to the desired position.
  2. While pushing the SET button, push button 1 or 2 until the signal beeps.
    • The beep sound means that the positions are recorded in the computer's memory.
    • By repeating these 2 steps and pressing the remaining button, the driving position for another driver can be recorded.
    • To set a new memorized position, select the desired position, and perform step 2). The previous memory will be erased and the new position will be set.
    • To make only slight changes to an already memorized position, the easiest way is to first activate the memorized position, then make the desired changes and perform step 2) above.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.