Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 143 (ENGINE CONTROLS - REMOVAL & INSTALLATION 4-CYLINDER)TORQUE SPECIFICATIONSHIGHLANDER
2004 Toyota Matrix XR, FWD, Standard
Torque Specifications: Highlander
2004 Toyota Matrix XR, FWD, StandardSECTION Highlander
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2003 Toyota Tacoma, 2003 Toyota RAV4, 2003 Toyota Prius, 2003 Toyota Matrix, and 2003 Toyota MR2. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS (HIGHLANDER)
| Application | Ft. Lbs. (N.m) | ||
|---|---|---|---|
| A/F Sensor | (1) | ||
| Control Lever Nut | 10 (13) | ||
| ECT Sensor | 15 (20) | ||
| Fuel Rail-To-Cylinder Head Bolt | 15 (20) | ||
| Heated Oxygen Sensor | (1) | ||
| Intake Manifold Bolt/Nut | 22 (30) | ||
| Knock Sensor | 29 (39) | ||
| Power Steering Pressure Switch | 15 (20) | ||
| Throttle Body Bolt | 22 (30) | ||
| INCH Lbs. (N.m) | |||
| Camshaft Position Sensor Bolt | 80 (9) | ||
| Crankshaft Position Sensor Bolt | 80 (9) | ||
| Fuel Pump Retaining Plate-To-Fuel Tank Bolt | (1) | ||
| Ignition Coil Bolt | 80 (9) | ||
| PNP Switch Retaining Bolt | 44 (5) | ||
| PNP Switch Retaining Nut | 62 (7) | ||
| VVT Camshaft Timing Oil Control Valve Retaining Bolt | 80 (9) | ||
|
|||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.