Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 130 (ENGINE CONTROL SYSTEM SELF DIAGNOSTICS)SELF-DIAGNOSTIC SYSTEMRETRIEVING DIAGNOSTIC TROUBLE CODESNORMAL MODE DIAGNOSTIC TROUBLE CODE RETRIEVAL
2004 Toyota Matrix XR, FWD, Standard
NORMAL Mode Diagnostic Trouble Code Retrieval
2004 Toyota Matrix XR, FWD, StandardSECTION NORMAL Mode Diagnostic Trouble Code Retrieval
WARNING: This page is about a different car, the 2003 Toyota MR2. However, it is still accessible from the selected car via links, so may be relevant.
- Connect Toyota hand-held tester or scan tool Data Link Connector No. 3 (DLC3). See Figure. Turn ignition on with engine off. Turn scan tool on. Using scan tool manufacturer's instructions, check for DTCs and freeze frame data.
- If scan tool does not display UNABLE TO CONNECT TO VEHICLE, go to next step. If scan tool displays UNABLE TO CONNECT TO VEHICLE, check DLC3. See DATA LINK CONNECTOR INSPECTION under SCAN TOOL PROBLEMS.
- Record any DTCs and freeze frame data displayed for system diagnosis. If driveability problem exists and no DTCs are present, go to TROUBLESHOOTING - NO CODES article for diagnosis by symptom.
- If any DTCs are present, perform appropriate DTC test under DIAGNOSTIC TESTS . For DTC descriptions, see DIAGNOSTIC TROUBLE CODE DEFINITIONS under DIAGNOSTIC TROUBLE CODE DEFINITIONS. For more information on freeze frame data, see FREEZE FRAME DATA . For information on two-trip detection logic DTCs, see TWO-TRIP DETECTION LOGIC .
- After repairs for DTC have been completed, DTC must be cleared from ECM. See CLEARING DIAGNOSTIC TROUBLE CODES . Road test vehicle to ensure all symptoms and/or complaints have been repaired.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.