Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 119 (ENGINE CONTROLS (REMOVAL & INSTALLATION))AIR INDUCTION SYSTEMINTAKE AIR CONTROL VALVEINSTALLATION (GS430 & LS430)
2004 Toyota Matrix XR, FWD, Standard
Installation (GS430 & LS430)
2004 Toyota Matrix XR, FWD, StandardSECTION Installation (GS430 & LS430)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 Lexus SC 430, 2003 Lexus RX 300, 2003 Lexus LX 470, 2003 Lexus LS 430, and 2003 Lexus IS 300. However, it is still accessible from the selected car via links, so may be relevant.
- To install, reverse removal procedure. Install NEW IAC valve actuator gasket. Slightly rotate actuator lever clockwise. See Fig 2. Connect actuator and air control valve levers. Install IAC valve.
- Install NEW intake manifold gaskets with White mark facing upward. Marks are painted on outer tabs of gasket. Ensure longer intake manifold bolts are installed in proper location. See Fig 3. Ensure to route IAC valve actuator vacuum hose under rear fuel line when reconnecting. Tighten all nuts/bolts to specification. See TORQUE SPECIFICATIONS .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.