Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Circuit Description
Battery positive voltage is not supplied to terminal +BM of the ECM for the electric throttle control system. See Fig 1. If this DTC is stored, the ECM shuts down the power for the throttle motor and the throttle valve is locked at a certain opening angle. However, the opening angle of the throttle valve can be controlled by the accelerator pedal through the throttle cable.
DTC is set when ECM detects an open in ETCS power source circuit. Possible causes are:
- Open in ETCS power source circuit.
- Faulty ECM.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.