Circuit Description

The accelerator pedal position sensor is mounted on the accelerator pedal bracket and it has 2 sensors to detect the accelerator position and a malfunction of the accelerator position sensor. In the accelerator pedal position sensor, the voltage applied to pedal terminals VPA and VPA2 of the ECM changes between 0-5 volts, in proportion to the opening angle of the accelerator pedal. The VPA is a signal to indicate the actual accelerator pedal opening angle which is used for the engine control, and the VPA2 is a signal to indicate the information about the opening angle which is used for detecting a malfunction. The ECM judges the current opening angle of the accelerator pedal from these signals input from terminals VPA and VPA2, and the ECM controls the throttle motor based on these signals. If these DTCs are stored, the throttle valve is locked at a certain opening angle. Electronically controlled throttle operation is cancelled until system returns to normal and the ignition switch is turned OFF. Possible cause is accelerator pedal position sensor.