SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1036 (AUDIO & VISUAL SYSTEM)RADIO RECEIVERREPLACEMENT
2004 Toyota Matrix XR, FWD, Standard

Radio Receiver: Replacement

2004 Toyota Matrix XR, FWD, StandardSECTION Replacement
WARNING: This page is about a different car, the 2004 Toyota Prius. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

  • : See COMPONENTS 
  • Installation is in the reverse order of removal.
  1. REMOVE INSTRUMENT PANEL REGISTER ASSY NO.3 (SEE  INSTRUMENT PANEL SUB-ASSY  ) 
  2. REMOVE INSTRUMENT PANEL REGISTER ASSY NO.4 (SEE  INSTRUMENT PANEL SUB-ASSY  ) 
  3. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSY CENTER (SEE  INSTRUMENT PANEL SUB-ASSY  ) 
  4. REMOVE MULTI-DISPLAY ASSY (SEE  REPLACEMENT  ) 
  5. REMOVE RADIO RECEIVER ASSEMBLY W/BRACKET 
    1. Remove the 4 screws.
    2. Disconnect the connector and remove the radio receiver-assembly w/ bracket.
    Fig 1: Removing Radio Receiver Assembly With Bracket
    G03629668Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. REMOVE RADIO BRACKET NO.1 
    1. Remove the 6 screws and radio bracket No.1.
    Fig 2: Removing Radio Bracket No. 1
    G03629669Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  7. REMOVE RADIO BRACKET NO.2 
    1. Remove the 6 screws and radio bracket No.2.
    Fig 3: Removing Radio Bracket No. 2
    G03629670Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  8. REMOVE RADIO RECEIVER ASSY 
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.