SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1036 (AUDIO & VISUAL SYSTEM)FRONT NO. 1 SPEAKERREPLACEMENT
2004 Toyota Matrix XR, FWD, Standard

Front No. 1 Speaker: Replacement

2004 Toyota Matrix XR, FWD, StandardSECTION Replacement
WARNING: This page is about a different car, the 2004 Toyota Prius. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

  • See COMPONENTS 
  • Use the same procedures for the RH side and LH side.
  • The procedures listed below are for the LH side.
  • Installation is in the reverse order of removal.
  1. REMOVE FRONT DOOR INSIDE HANDLE BEZEL LH (SEE  OVERHAUL  ) 
  2. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH (SEE  OVERHAUL  ) 
  3. REMOVE DOOR PULL HANDLE (SEE  OVERHAUL  ) 
  4. REMOVE FRONT ARMREST BASE PANEL UPPER LH (SEE  OVERHAUL  ) 
  5. REMOVE FRONT DOOR GLASS WEATHERSTRIP INNER LH (SEE  OVERHAUL  ) 
  6. REMOVE FRONT DOOR TRIM BOARD SUB-ASSY LH (SEE  OVERHAUL  ) 
  7. REMOVE FRONT NO.1 SPEAKER ASSY 
    1. Disconnect the connector.
    2. Drill out the 3 rivet heads using a drill with a bit diameter of less than 4 mm (0.16 in.), and remove the front No.1 speaker assy from the front door panel.
      Fig 1: Drilling Out Rivet Heads
      G03629672Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Operate the drill along the rivet head circumference and cut out the flange.
      NOTE: Prying the rivet using a drill may scratch the rivet hole or break the drill bit.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.