SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004MATRIX XR, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1017 (GARAGE DOOR OPENER SYSTEM)REGISTRATION PROCEDURE
2004 Toyota Matrix XR, FWD, Standard

Registration Procedure

2004 Toyota Matrix XR, FWD, StandardSECTION Registration Procedure
WARNING: This page is about a different car, the 2004 Lexus IS 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. NEW CODE REGISTRATION 
    NOTE:
    • If pressing the switch of the original transmitter to register the code, the system might operate. 
    • When registering the transmitter codes such as for garage or gate, check that there is nobody around those places then register. 
    1. Press the switch for the item to be registered for 20 seconds

      HINT:

      When transferring to registration mode, LED (red) blinks in 1 Hz cycle.

    2. In the condition of ( a), bring the original transmitter to within 1-inch area around the garage door opener and press the switch, (code transmitting).

      HINT:

      When code registration completes correctly, LED (red) blinks in 5.6 Hz cycle.

    Fig 1: Bringing Original Transmitter To Within 1-Inch Area Around Garage Door Opener
    G03494495Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    New code registration timing chart 

    Fig 2: New Code Registration Timing Chart
    G03494496Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    If a code can not be registered, observe the following conditions.

    HINT:

    • If the battery of original transmitter is consumed.
    • Press the switch of the transmitter repeatedly in registration mode, as some transmitters stop transmitting for 1 to 2 seconds.
    • This system is not applicable to the garage door opener which had been made before 1982.
  2. CODE DELETION 
    1. Press the switches at both ends of garage door opener simultaneously for 20 seconds.

      HINT:

      When transferring to deletion mode, LED (red) blinks in 6 Hz cycle.

    2. When releasing the switch within 10 seconds after transferring to deletion mode, all the registered codes will be erased.

      HINT:

      Press the switch until blinking in 6 Hz cycle stops, so that the default code for check is set.

    Code deletion timing chart 

    Fig 3: Code Deletion Timing Chart
    G03494497Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.