Check Mode Procedure

2004 Toyota Matrix XR, FWD, StandardSECTION Check Mode Procedure
NOTE:

Hand-held tester only:

Compared to the normal mode, the check mode has more sensing ability to detect malfunctions. Furthermore, the same diagnostic items which are detected in the normal mode can also be detected in the check mode.

  1. CHECK MODE PROCEDURE (Using the hand-held tester)Β 
    1. Check the initial conditions.
      1. Battery positive voltage 11 V or more
      2. Throttle valve fully closed
      3. Transmission in the P or N position
      4. A/C switched OFF
    2. Turn the ignition switch OFF.
    3. Connect the hand-held tester to the DLC3.
      Fig 1: Connecting Hand-Held Tester To DLC3
      G02914402Courtesy of Β© TOYOTA, LICENSE AGREEMENT TMS1002
    4. Turn the ignition switch ON.
    5. NOTE: If the hand-held tester switches the ECM from the normal mode to the check mode or vice-versa, or if the ignition switch is turned from ON to ACC or OFF during the check mode, the DTC and freeze frame data will be erased.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.