Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004CELICA GT, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 84 (ENGINE CONTROLS - ON-VEHICLE ADJUSTMENTS)IGNITION TIMINGES300USING SCAN TOOL
2004 Toyota Celica GT, Standard
Using Scan Tool
2004 Toyota Celica GT, StandardSECTION Using Scan Tool
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2003 Lexus SC 430, 2003 Lexus RX 300, 2003 Lexus LX 470, 2003 Lexus LS 430, and 2003 Lexus IS 300. However, it is still accessible from the selected car via links, so may be relevant.
- Remove intake manifold cover located on top of engine. Start and warm engine up to normal operating temperature. Shut engine off. Connect scan tool to DLC3. See Figure. Use scan tool to read engine RPM.
- Connect timing light to lead wire at ignition coil electrical connector on top of driver's side valve cover at cylinder No. 1. See Figure. Cylinder No. 1 is front cylinder on right side of engine when viewed from timing belt end of engine. See Figure.
- Apply parking brake. Place transmission in Neutral. Ensure idle speed is 550-650 RPM. Check timing marks located on timing belt cover, near crankshaft pulley. Ensure base timing is 8-12 degrees BTDC at idle with A/C and all accessories off. Shut engine off. Remove timing light and scan tool. Reinstall intake manifold cover.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.