SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSTOYOTA2004CELICA GT, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 470 (LIGHTING)HEIGHT CONTROL SENSORREPLACEMENT
2004 Toyota Celica GT, Standard

Height Control Sensor: Replacement

2004 Toyota Celica GT, StandardSECTION Replacement
WARNING: This page is about a different car, the 2004 Lexus ES 330. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE HEIGHT CONTROL SENSOR SUB-ASSY REAR RH 
    1. Disconnect the connector.
    2. Align matchmark with the one on the height control sensor sub-assy rear RH and bracket.
    3. Remove a nut.
      Fig 1: Removing Nut
      G03484111Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Remove the 2 nuts and height control sensor sub assy rear RH.
      Fig 2: Removing Nuts And Height Control Sensor Sub Assy Rear RH
      G03484112Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL HEIGHT CONTROL SENSOR SUB-ASSY REAR RH 
    1. Install the height control sensor link rear RH with the 2 nuts.

      Torque: 8.0 N.m (81 kgf.cm, 71 in.lbf) 

    2. Align the matchmark with the one on the height control sensor sub assy rear RH and bracket.
    3. Install the height control sensor sub assy rear RH

      Torque: 5.4 N.m (55 kgf.cm, 48 in.lbf) 

    4. Connect the connector.
    5. When the work like the vehicle height may be changed is performed, for example, removal and installation of the height control sensor, or replacement of the suspension, etc., initialize the sensor, then adjust the optical axis.(See LIGHTING SYSTEM - DIAGNOSIS )
  3. HEADLIGHT AIM ONLY (See  ADJUSTMENT   ) 
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.